A pump rotor set is the matched rotating group of a three-screw pump: the central power rotor and the two idler screws that mesh with it. In most designs the set also carries the idler pins or shaft components that keep the screws in mesh. Rotor and idlers are lapped together, and they are replaced together. Fitting one new screw against two worn ones destroys the clearances that make a three-screw pump quiet and efficient.
This category carries rotor sets for IMO ACE, ACG, ACD and ACP pumps and for Allweiler SPF10 and SPF20 pumps. References follow the pump's own identification: series, size, material code and maker's part number, as in an IMO G012 set for an ACG 52 K7 or an Allweiler SPF10-38 set.
What a pump rotor set covers
The set is a hydraulic assembly, not a spare screw. Screw lead, profile and running clearance are matched, and the clearance itself depends on the fit between the flanks, the housing bore and the idler pins. A G012 set built for one pump size does not transfer to another. The suffix after the size in a reference, N3, L3, N6, L6, K7 or N7, is part of the identity and is not a cosmetic code.
Fluid decides how long the set lasts. Fuel oil, lube oil and hydraulic fluid all lubricate the screw flanks; water-based and low-lubricity fluids do not. A set that has run dry, or on a fluid with poor lubricity, usually shows scoring along the idler flanks and heat discoloration on the power rotor before any other symptom appears. Vibration and falling discharge pressure follow later.
How to specify
- Pump series and size. ACE 25, 32 or 38; ACG 45, 52 or 60; ACD and ACP 025; Allweiler SPF10 or SPF20.
- Full set part number, including the suffix. A G012 N7 is not a G012 K7, and the difference is not visible on the screws.
- Material and clearance code as stamped on the pump plate or the old rotor.
- Housing condition. A new set in a worn bore or on worn idler pins will lose clearance within weeks.
- Fluid and duty. Viscosity, temperature, lubricity and whether the pump has ever run dry.
Typical applications
- Marine fuel oil booster and transfer service
- Lube oil circulation on turbine and genset skids
- Hydraulic power units on deck machinery
- Burner and boiler fuel feed
- Cargo oil stripping and tank transfer
What we supply in this range
Ordering and cross-reference
A rotor set order needs the pump model, the set number, the size and the suffix, and ideally the old rotor for comparison. Photographs of the screw flanks, the idler pin bores and the housing bore tell us whether a set alone will restore the pump or whether bearings and pins are also due. Victor's checks the reference against the pump plate before quoting, because a single digit in a three-screw reference changes the lead and the fit. If the plate is unreadable, measure the rotor outside diameter, the screw length and the idler pin bore.
FAQ
Can I replace only the power rotor?
No. The idlers wear against the rotor and are lapped as a set. A single screw against worn partners will not hold clearance or pressure.
What usually kills a rotor set?
Dry running, poor lubricity and contaminated fluid. All three remove the film that keeps the flanks apart, and scoring follows quickly. Our note on IMO rotor sets in IMO pumps covers the failure pattern in more detail.