WWKS single and double mechanical seal for Waukesha U-1/U-2 200 series

Material

FKM/EPDM
Carbon
Ceramic
Silicone carbide
Stainless steel

Description

WWKS single and double mechanical seal for Waukesha U-1/U-2 200 series is a replacement mechanical seal for Waukesha pumps, built to the original mounting envelope. It is normally specified for pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Faces are silicon carbide against carbon graphite, with FKM secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.

Before fitting, record shaft diameter, seal chamber bore and depth; the axial working height is set from those three measurements, not from the old seal alone. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the OEM pump seals line. Related units in the same family include Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC and OEM cartridge mechanical seal for taiko kikai marine pump shaft size 35mm HC-51MJ. Include the quantity and the required elastomer option with the enquiry.