


WUS-2 O-Ring Shaft Seal To Replace Nippon Pillar US-2
Features
• Robust O-Ring mounted Mechanical Seal
• Capable of many shaft-sealing duties
• Unbalanced pusher-type Mechanical Seal
Combination Material
Rotary Ring
Carbon, SIC, SSIC, TC
Stationary Ring
Carbon, Ceramic, SIC, SSIC, TC
Secondary Seal
NBR/EPDM/Viton
Spring
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Metal Parts
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Operating Ranges
• Mediums: Water, oil, acid, alkali, etc.
• Temperature: -20°C~180°C
• Pressure: ≤1.0MPa
• Speed: ≤ 10 m/Sec
Maximum Operating Pressure Limits primarily depend upon Face Materials, Shaft Size, Speed and Media.
Advantages
Pillar seal is widely used for big sea ship pump, In order to prevent corrosion by sea water, it is furnished with mating face of plasma flame fusible ceramics. so it is a marine pump seal with ceramic coated layer on the seal face, offer more resistance against sea water.
It can be used in reciprocating and rotary movement and can adapt to most fluids and chemicals. Low friction coefficient, no crawling under precise control, good anti-corrosion capability and good dimensional stability. It can withstand rapid temperature changes.
Suitable Pumps
Naniwa Pump, Shinko Pump, Teiko Kikai, Shin Shin for BLR Circ water, SW Pump and many other applications.
WUS-2 dimension data sheet (mm)
Description
WUS-2 O-Ring Shaft Seal To Replace Nippon Pillar US-2 covers Nippon Pillar pump duty as a direct replacement for the original part. Typical duty is marine and offshore auxiliary pumps. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Sealing geometry follows the original, built around O-ring mounting that keeps the spring out of the pumped medium. Faces are silicon carbide against carbon graphite, with FKM secondary sealing as standard.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.
Clean the chamber and the shaft before fitting; grit left in the bore will tilt the gland. A seal that has run dry shows heat colouring on the faces before it shows a leak.
EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Orders are matched on pump model, shaft size and medium. The unit belongs to the mechanical seal line. Related units in the same family include WE41 O-ring mechanical seals replace Burgmann BT-RN and WMG912 replacement of Burgmann MG912, Single Seal unbalanced mechanical shaft sea. Include the quantity and the required elastomer option with the enquiry. A seal that has run dry shows heat colouring on the faces before it shows a leak.