WMFWT80 Metal Bellow mechanical seals replace Burgmann MFLWT80

Features

• For unstepped shafts
• Single Seal
• Balanced
• Independent of direction of rotation
• Metal bellows rotating

Advantages

• For extreme high temperature ranges
• No dynamically loaded O-Ring
• Self-cleaning effect
• Short installation length possible
• Pumping screw for highly viscous media available (dependent on direction of rotation).

Recommended applications

• Process industry
• Oil and gas industry
• Refining technology
• Petrochemical industry
• Chemical industry
• Pulp and paper industry
• Hot media
• Highly viscous media
• Pumps
• Special rotating equipment

Combination material

STATIONARY RING: CAR/ SIC/ TC
ROTARY RING: CAR/ SIC/ TC
SECONDARY SEAL:  GRAQHITE
SPRING AND METAL PARTS: SS/ H-C
BELLOW: AM350

wmfwt80

WMFWT80 Data Sheet of Dimension (mm)

WMFWT80 data sheet of dimension

Description

WMFWT80 Metal Bellow mechanical seals replace Burgmann MFLWT80 is a replacement seal supplied for general pump duty. Most units go into pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

Internally the seal uses a welded metal bellows that takes the elastomer out of the load path. Standard build pairs silicon carbide with carbon graphite faces and NBR O-rings.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.

Check the shaft for wear at the secondary seal track and the chamber for scoring before the new unit goes on. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the mechanical seal range line. For a different shaft size, see WMFL85N Metal Bellow Mechanical Seals Replace Eagle Burgmann MFL85N or Metal bellow balanced pump mechanical seals WMF95N. Include the quantity and the required elastomer option with the enquiry. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.