WM74D Double face mechanical seals replacement of Burgmann M74D

Features

• For plain shafts
• Dual seal
• Unbalanced
• Rotating multiple springs
• Independent of direction of rotation
• Seal concept based on the M7 range

Advantages

• Efficient stock keeping due to easily interchangeable faces
• Extended selection of materials
• Flexibility in torque transmissions
• EN 12756 (For connection dimensions d1 up to 100 mm (3.94″))

Recommended applications

• Chemical industry
• Process industry
• Pulp and paper industry
• Low solids content and low abrasive media
• Toxic and hazardous media
• Media with poor lubrication properties
• Adhesives

Operating range

Shaft diameter:
d1 = 18 … 200 mm (0.71″ … 7.87″)
Pressure:
p1 = 25 bar (363 PSI)
Temperature:
t = -50 °C … 220 °C
(-58 °F … 428 °F)
Sliding velocity:
vg = 20 m/s (66 ft/s)
Axial movement:
d1 up to 100 mm: ±0.5 mm
d1 from 100 mm: ±2.0 mm

Combination material

Stationary Ring (Carbon/SIC/TC)
Rotary Ring (SIC/TC/Carbon)
Secondary Seal (VITON/PTFE+VITON)
Spring & Other Parts (SS304/SS316)

wm74d

WM74D data sheet of dimension (mm)

Double face mechanical seals are designed to ensure that mechanical seals can work in a maximum sealing mode. Double face mechanical seals virtually remove leakage of the fluid or gas in pumps or mixers. Double mechanical seals provide a level of safety and minimize pump emission compliance not possible with single seals.It is essential to pump or mix a dangerous or toxic substance.

Double mechanical seals are mostly used in flammable, explosive, toxic, granular and lubricating medium. When it is used, it needs a sealing auxiliary system, that is, the isolation fluid is inserted in the sealing cavity between the two ends, thereby improving the lubrication and cooling conditions of the mechanical seal. The pump products that use double mechanical seal are: fluorine plastic centrifugal pump or IH stainless steel chemical pump, etc.

WM74D data sheet of dimension

Description

WM74D Double face mechanical seals replacement of Burgmann M74D is a replacement mechanical seal built to a standard mounting envelope. Typical duty is process water in general industry. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Keep the faces clean during fitting; a single grit particle will open a leak path.

Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. A seal that has run dry shows heat colouring on the faces before it shows a leak.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the mechanical seal selection line. Two close alternatives are WH7N O-Ring Component mechanical seals, Eagle burgmann H7N replacement and WHJ92N Wave Spring Mechanical Seals Replacement For Burgmann HJ92N. Include the quantity and the required elastomer option with the enquiry.

The reference carried by this unit is WM74D. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.