WM2N Conical Spring Mechanical Seal Replace Burgmann M2N

Features

Conical spring, unbalanced,O-ring pusher construction
Torque transmission via conical spring,  independent    of direction of rotation.
Solid carbon graphite or silicone carbide in rotary face

Recommended Applications

Basic applications such as circulating pumps for water and heating system.
Circulating pumps and centrifugal pumps
Other Rotating Equipment.

Operating range

Shaft diameter: d1=10…38mm
Pressure: p=0…1.0Mpa(145psi)
Temperature: t = -20 °C …180 °C(-4°F to 356°F)
Sliding velocity: Vg≤15m/s(49.2ft/m)

Notes: The range of pressure, temperature and sliding velocity is depend on seals combination material

Combination material

Rotary Face
Carbon graphite resin impregnated
Silicon carbide (RBSIC)
Stationary Seat
Silicon carbide (RBSIC)
Aluminium Oxide Ceramic
Auxiliary Seal
Nitrile-Butadiene-Rubber (NBR)
Fluorocarbon-Rubber (Viton)
Ethylene-Propylene-Diene (EPDM)
Spring
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Left rotation:L Right rotation:
Metal Parts
Stainless Steel (SUS304)
Stainless Steel (SUS316)

wm2n

WM2N data sheet of dimension (mm)

WM2N data sheet of dimension

Our service

Quality: We have a strict quality control system. All products ordered from our factory are inspected by a professional quality control team.
After-sales service: We provide after-sales service team, all problems and questions will be resolved by our after-sales service team.
MOQ: We accept small orders and mixed orders. According to our customers’ requirements, as a dynamic team, we want to connect with all our customers.
Experience: As a dynamic team, through our more than 20 years of experience in this market, we are still continuing to research and learn more knowledge from customers, hoping that we can become the largest and professional supplier in China in this market business one.
OEM: we can produce customerized products according to customer requirement.

Description

WM2N Conical Spring Mechanical Seal Replace Burgmann M2N is a replacement seal supplied for general pump duty. Most units go into clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The design is built around a conical spring that keeps the seal short in axial length. Faces are silicon carbide against carbon graphite, with NBR secondary sealing as standard. It is a balanced design, so face loading stays controlled as pressure rises.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.

Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the mechanical seals line. Two close alternatives are WE41 O-ring mechanical seals replace Burgmann BT-RN and W20 Single spring mechanical seals replace Vulcan Diaphragm Type 20. Include the quantity and the required elastomer option with the enquiry.