WEMG1 rubber bellow mechanical shaft seal for water pump

Features

For plain shafts
Single and dual seal
Elastomer bellows rotating
Balanced
Independent of direction of rotation test

Advantages

100 % compatible with MG1

Small outer diameter of bellows support (dbmin) enables direct retaining ring support, or smaller spacer rings
Optimal alignment characteristic through self-cleaning of disk/shaft
Improved centering across entire pressure operating range

No torsion on bellows
Shaft protection over entire seal length
Protection of seal face during installation due to special bellows design
Insensitive to shaft deflections due to large axial movement ability
Suitable for low-end sterile applications

Recommended applications

Fresh water supply
Building services engineering
Waste water technology
Food technology
Sugar production
Pulp and paper industry
Oil industry
Petrochemical industry
Chemical industry
Water, waste water, slurries(solids up to 5 % by weight)
Pulp (up to 4 % otro)
Latex
Dairies, beverages
Sulfide slurries
Chemicals
Oils
Chemical standard pumps
Helical screw pumps
Stock pumps
Circulating pumps
Submersible pumps
Water and waste water pumps

Operating range

Shaft diameter:
d1 = 14 … 110 mm (0.55″ … 4.33″)
Pressure: p1 = 18 bar (261 PSI),
vacuum … 0.5 bar (7.25 PSI),
up to 1 bar (14.5 PSI) with seat locking
Temperature: t = -20 °C … +140 °C
(-4 °F … +284 °F)
Sliding velocity: vg = 10 m/s (33 ft/s)
Admissible axial movement: ±2.0 mm (±0.08″)

Combination material

Stationary Ring: Ceramic, Carbon, SIC, SSIC, TC
Rotary Ring: Ceramic, Carbon, SIC, SSIC, TC
Secondary Seal: NBR/EPDM/Viton
Spring and Metal Parts: SS304/SS316

wemg1

WEMG1 Data Sheet of Dimension (mm)

WeMG1 data sheet of dimension

Description

WEMG1 rubber bellow mechanical shaft seal for water pump is a replacement seal supplied for general pump duty. It is normally specified for cooling water and service water circuits. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The design is built around an elastomer bellows that seals on the shaft without a separate gasket. The face pair is carbon graphite running on silicon carbide; secondary seals are NBR. The unit is unbalanced, which suits the lower pressure range it is designed for.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. A short dry run is enough to score the faces, so prime the chamber before start-up.

Measure shaft diameter, chamber depth and working height before stripping the old unit; the new seal is set to those numbers, not to the dimensions of the worn part. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Orders are matched on pump model, shaft size and medium. The unit belongs to the mechanical seal range line. For a different shaft size, see Elastomer rubber mechanical seals Vulcan Type 19B for water pump or welded type metal bellow mechanical seal John crane W680 for pump. Include the quantity and the required elastomer option with the enquiry.