
WE41 O-ring mechanical seals replace Burgmann BT-RN
Features
• Single pusher-type seal
• Unbalanced
• Conical spring
• Dependent on direction of rotation
Recommended Applications
• Chemical industry
• Building services industry
• Centrifugal pumps
• Clean water pumps
Operating Range
• Shaft diameter:
RN, RN3, RN6:
d1 = 6 … 110 mm (0.24″ … 4.33″),
RN.NU, RN3.NU:
d1 = 10 … 100 mm (0.39″ … 3.94″),
RN4: upon request
Pressure: p1* = 12 bar (174 PSI)
Temperature:
t* = -35 °C … +180 °C (-31 °F … +356 °F)
Sliding velocity: vg = 15 m/s (49 ft/s)
* Dependent on medium, size and material
Combination Materials
Rotary Face
Silicon carbide (RBSIC)
Tungsten carbide
Cr-Ni-Mo Sreel (SUS316)
Tungsten carbide surfacing
Stationary Seat
Carbon graphite resin impregnated
Silicon carbide (RBSIC)
Tungsten carbide
Auxiliary Seal
Nitrile-Butadiene-Rubber (NBR)
Fluorocarbon-Rubber (Viton)
Ethylene-Propylene-Diene (EPDM)
Fluorocarbon-Rubber (Viton)
Spring
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Left rotation: L Right rotation:
Metal Parts
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Specification
Description
WE41 O-ring mechanical seals replace Burgmann BT-RN is a replacement mechanical seal built to a standard mounting envelope. Most units go into cooling water and service water circuits. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Sealing geometry follows the original, built around a conical spring that keeps the seal short in axial length. Faces are tungsten carbide against silicon carbide, with NBR secondary sealing as standard. It is a balanced design, so face loading stays controlled as pressure rises.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Keep the faces clean during fitting; a single grit particle will open a leak path.
Check the shaft for wear at the secondary seal track and the chamber for scoring before the new unit goes on. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the pump mechanical seal line. Two close alternatives are WM3N O-ring mechanical seals Burgmann M3N replacement and W155 O-ring single spring pump seals replace Burgmann BT-FN. Include the quantity and the required elastomer option with the enquiry.
The reference carried by this unit is WE41. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.