


WALP OEM pump mechanical seals for KRAL pump, ALP series
Application
For Alfa Laval KRAL pump, Alfa laval ALP series
Material
SIC, TC, VITON
Size:
16mm,25mm,35mm
Description
WALP OEM pump mechanical seals for KRAL pump, ALP series is used to replace the original seal on KRAL pumps in service, on the same shaft and chamber dimensions. It is normally specified for process water in general industry. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Faces are tungsten carbide against silicon carbide, with FKM secondary sealing as standard. It is a balanced design, so face loading stays controlled as pressure rises.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. A seal that has run dry shows heat colouring on the faces before it shows a leak.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.
Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM mechanical seals manufacturer line. Two close alternatives are OEM mechanical seals for IMO pump series ACG/UCG XVXX 190335 and OEM pump mechanical seals for IMO ACG/UCG series 174102. Include the quantity and the required elastomer option with the enquiry.