


W8X OEM water pump shaft seal for Allweiler pump replce Vulcan type 8X
Features
‘O’-Ring mounted conical spring 22mm seals with distinctive gasket mounted seat rings, to suit “SOB” and “SOH” series pumps, commonly found in ship’s engine rooms. Clockwise rotation springs are standard.
Type W8X diamension sheet
Description
W8X OEM water pump shaft seal for Allweiler pump replce Vulcan type 8X covers Allweiler pump duty as a direct replacement for the original part. Typical duty is process water in general industry. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a conical spring that keeps the seal short in axial length. The face pair is carbon graphite running on silicon carbide; secondary seals are NBR.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.
Measure shaft diameter, chamber depth and working height before stripping the old unit; the new seal is set to those numbers, not to the dimensions of the worn part. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the OEM mechanical seals range line. For a different shaft size, see WSPF pump seal For Allweiler Pump SPF10, SPF20 replace Vulcan Type 8W or OEM pump shaft seal for Allweiler pump art no.38543. Include the quantity and the required elastomer option with the enquiry.