W60 Rubber bellows Mechanical Seal replace Vulcan type 60

Features

• Rubber bellows mechanical seal
• Unbalanced
• Single spring
• Independent of direction of rotation

Recommended applications

• Water and waste water technology
• Pool and spa applications
• Household appliances
• Swimming pool pumps
• Cold water pumps
• Pumps for home and garden

Operating range

Shaft diameter: d1 = 15 mm, 5/8”, 3/4”, 1″
Pressure: p1*= 12 bar (174 PSI)
Temperature: t* = -20 °C … +120 °C (-4 °F … +248 °F
Sliding velocity: vg = 10 m/s (33 ft/s)
* Dependent on medium, size and material

Combination material

Seal face
Carbon graphite resin impregnated , Carbon graphite, full carbon Silicon carbide

Seat
Ceramic, Silicon, carbide

Elastomers
NBR , EPDM , FKM,VITON

Metal parts
SS304, SS316

W60 Data Sheet of Dimension (mm)

w60
W60 data sheet of dimension

Our advantages

Customization
We have a strong R&D team, and we can develop and produce products according to the drawings or samples the customers offered,

Low Cost
We are production factory, compared with the trading company, we has great advantages

High Quality
Strict material control and perfect testing equipment to ensure product quality

Multiformity
Products include slurry pump mechanical seal, agitator mechanical seal, paper industry mechanical seal, dyeing machine mechanical seal etc.

Good Service
We focus on developing high-quality products for top-end markets. Our products are in line with international standards

How to order

In ordering mechanical seal, you are requested to give us complete information as specified below:

1. Purpose: For which equipments or what factory use.
2. Size: Diameter of the seal in millimeter or inches
3. Material: what kind of material, strength requirement.
4. Coating: stainless steel, ceramic, hard alloy or silicon carbide
5. Remarks: Shipping marks and any other special requirement.

Description

W60 Rubber bellows Mechanical Seal replace Vulcan type 60 is a replacement mechanical seal built to a standard mounting envelope. Typical duty is pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The design is built around a single coil spring driving the seal through one central load path. Faces are silicon carbide against carbon graphite, with FKM secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. A short dry run is enough to score the faces, so prime the chamber before start-up.

Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the mechanical seal selection line. Related units in the same family include Elastomer rubber mechanical seals Vulcan Type 19B for water pump and W1A Elastomer Bellows Shaft Seal replace John crane type 1A. Include the quantity and the required elastomer option with the enquiry.

The reference carried by this unit is W60. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.