W1A Elastomer Bellows Shaft Seal replace John crane type 1A

Features

To absorb both breakout and running torque, the seal is designed with a drive band and drive notches that eliminate overstressing of bellows. Slippage is eliminated, protecting the shaft and sleeve from wear and scoring.
Automatic adjustment compensates for abnormal shaft-end play, run-out, primary ring wear and equipment tolerances. Uniform spring pressure compensates for axial and radial shaft movement.
Special balancing accommodates higher-pressure applications, greater operating speeds and lower wear.
Non-clogging, single-coil spring allows for greater dependability than multiple spring designs. Will not run foul due to fluid contact.
Low drive torque improves performance and reliability.

Recommended applications

For pulp and paper,
petrochemical,
food processing,
wastewater treatment,
chemical processing,
power generation

Operating range

Temperature: -40°C to 205°C/-40°F to 400°F (depending on materials used)
Pressure: 1: up to 29 bar g/425 psig 1B: up to 82 bar g/1200 psig
Speed: See enclosed speed limits chart.

Combination material

Stationary Ring: Ceramic, SIC, SSIC, Carbon, TC
Rotary Ring: Ceramic, SIC, SSIC, Carbon, TC
Secondary Seal: NBR, EPDM, Viton
Spring and Metal Parts: SS304, SS316

W1A Data Sheet of Dimension (mm)

W1A data sheet of dimension

Our Service

Quality: We have a strict quality control system. All products ordered from our factory are inspected by a professional quality control team.
After-sales service: We provide after-sales service team, all problems and questions will be resolved by our after-sales service team.
MOQ: We accept small orders and mixed orders. According to our customers’ requirements, as a dynamic team, we want to connect with all our customers.
Experience: As a dynamic team, through our more than 20 years of experience in this market, we are still continuing to research and learn more knowledge from customers, hoping that we can become the largest and professional supplier in China in this market business one.
OEM: we can produce customerized products according to customer requirement.

Description

W1A Elastomer Bellows Shaft Seal replace John crane type 1A is a replacement mechanical seal built to a standard mounting envelope. It is normally specified for light-duty chemical transfer. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The unit is assembled around an elastomer bellows that seals on the shaft without a separate gasket. Standard build pairs carbon graphite with silicon carbide faces and NBR O-rings. The unit is unbalanced, which suits the lower pressure range it is designed for.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Running the pump dry, even briefly, will damage the faces.

Before fitting, record shaft diameter, seal chamber bore and depth; the axial working height is set from those three measurements, not from the old seal alone. A seal that has run dry shows heat colouring on the faces before it shows a leak.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the Victor’s mechanical seal range line. Related units in the same family include Type W1 Elastomer Bellows Shaft Pump Seal Replaced John Crane Type 1 and W502 John Crane Type 502 Replacement Unitized Elastomer Bellows Seal For Pumps. Include the quantity and the required elastomer option with the enquiry.