Vulcan Type 96 Parallel O-Ring Mounted Mechanical Seals

Features

– Robust ‘O’-Ring mounted Mechanical Seal
– Unbalanced pusher-type Mechanical Seal
– Capable of many shaft-sealing duties
– Available as standard with the Type 95 stationary

Operating Limits

– Temperature: -30°C to +140°C
– Pressure: Up to 12.5 bar (180 psi)
– For full Performance Capabilities please check data sheet
– Limits are for guidance only. Product performance is dependent on materials and other operating conditions.

Specification

Specification

Description

Vulcan Type 96 Parallel O-Ring Mounted Mechanical Seals is a like-for-like replacement unit for standard pump seal chambers. Typical duty is building services and HVAC plant. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is O-ring mounting that keeps the spring out of the pumped medium. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.

Service limits are -30 °C to 140 °C, pressure to 12.5 bar and face speed to 25 m/s. A short dry run is enough to score the faces, so prime the chamber before start-up.

Measure shaft diameter, chamber depth and working height before stripping the old unit; the new seal is set to those numbers, not to the dimensions of the worn part. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Orders are matched on pump model, shaft size and medium. The unit belongs to the single spring mechanical seal line. Two close alternatives are Conical ‘O’-Ring Mounted Mechanical Seals Vulcan Type 8 DIN and W20 Single spring mechanical seals replace Vulcan Diaphragm Type 20. Include the quantity and the required elastomer option with the enquiry.