stainless steel mechanical seal parts

Description

stainless steel mechanical seal parts is a replacement seal supplied for general pump duty. Most units go into food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. The face pair is carbon graphite running on silicon carbide; secondary seals are NBR. It is a balanced design, so face loading stays controlled as pressure rises.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.

Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. A seal that has run dry shows heat colouring on the faces before it shows a leak.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the Victor’s seal spare parts line. Two close alternatives are Flygt-4 stainless steel cartridge mechanical seal for Flygt Xylem pump and WMG912 replacement of Burgmann MG912, Single Seal unbalanced mechanical shaft sea. Include the quantity and the required elastomer option with the enquiry.