SIC and SSIC ring

Silicon Carbide Performance Index

sic and ssic ring data ring

Description

SIC and SSIC ring is a like-for-like replacement unit for standard pump seal chambers. It is normally specified for clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Faces are silicon carbide against carbon graphite, with NBR secondary sealing as standard.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.

Measure shaft diameter, chamber depth and working height before stripping the old unit; the new seal is set to those numbers, not to the dimensions of the worn part. A seal that has run dry shows heat colouring on the faces before it shows a leak.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the seal spare parts line. Two close alternatives are Carbon Ring and Ceramic ring. Include the quantity and the required elastomer option with the enquiry. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start.