


OEM sic multi-spring Taiko pump mechanical seal marine industry
Taiko 520 Mechanical Seal & Sleeve
Material: silicone carbide, carbon, viton
Shaft size: 20mm,30mm,40mm,50mm
Description
OEM sic multi-spring Taiko pump mechanical seal marine industry covers Taiko pump duty as a direct replacement for the original part. Most units go into food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Internally the seal uses a multi-spring carrier that spreads the spring load evenly over the sealing face. The face pair is silicon carbide running on carbon graphite; secondary seals are FKM. The unit is unbalanced, which suits the lower pressure range it is designed for.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the Victor’s OEM mechanical seals range line. Related units in the same family include OEM cartridge mechanical seal for taiko kikai marine pump shaft size 35mm HC-51MJ and OEM cartridge mechanical shaft seal for Naniwa pump 34.4mm. Include the quantity and the required elastomer option with the enquiry.