OEM mechanical seals for IMO pump series ACG/UCG XVXX 190335

Product Parameters

OEM mechanical 1
OEM mechanical 2

Description

OEM mechanical seals for IMO pump series ACG/UCG XVXX 190335 is the replacement option for IMO pumps where the factory part is no longer stocked. It is normally specified for clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Standard build pairs carbon graphite with silicon carbide faces and NBR O-rings. The unit is unbalanced, which suits the lower pressure range it is designed for.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.

Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Orders are matched on pump model, shaft size and medium. The unit belongs to the Victor’s OEM mechanical seals range line. Related units in the same family include OEM pump mechanical seals for IMO ACG/UCG series 174102 and OEM shaft mechanical seals for IMO ACD series XVXX 192691. Include the quantity and the required elastomer option with the enquiry.

The reference carried by this unit is 190335. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.