

OEM cartridge mechanical shaft seal for Naniwa pump 34.4mm
NANIWA TYPE:BBH-50DNC
Material: SIC, carbon, TC, Viton
Shaft size: 34.4mm
Description
OEM cartridge mechanical shaft seal for Naniwa pump 34.4mm is used to replace the original seal on Naniwa pumps in service, on the same shaft and chamber dimensions. Typical duty is clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The load path runs through a cartridge build that is set on the bench and fitted as one unit. The face pair is tungsten carbide running on silicon carbide; secondary seals are FKM. It is a balanced design, so face loading stays controlled as pressure rises.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.
Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the OEM seal replacement line. For a different shaft size, see OEM cartridge mechanical seal for taiko kikai marine pump shaft size 35mm HC-51MJ or Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC. Include the quantity and the required elastomer option with the enquiry.