


O ring carbon mechanical seals 166 for water pump
Specification


Description
O ring carbon mechanical seals 166 for water pump is a replacement mechanical seal built to a standard mounting envelope. Typical duty is pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is O-ring mounting that keeps the spring out of the pumped medium. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.
Clean the chamber and the shaft before fitting; grit left in the bore will tilt the gland. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.
EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.
Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the mechanical seal line. For a different shaft size, see Elastomer rubber mechanical seals Vulcan Type 19B for water pump or Eagle burgmann multi spring H75F mechanical seals for water pump. Include the quantity and the required elastomer option with the enquiry.