

Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC
Victor provides mechanical seals for boiler water pumps. Metal bellow cartridge mechanical seal for Naniwa pump type BBH-50DNC
Description
Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC is used to replace the original seal on Naniwa pumps in service, on the same shaft and chamber dimensions. It is normally specified for food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The unit is assembled around a welded metal bellows that takes the elastomer out of the load path. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.
Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the Victor’s OEM seal replacement line. For a different shaft size, see OEM cartridge mechanical shaft seal for Naniwa pump 34.4mm or OEM cartridge mechanical seal for taiko kikai marine pump shaft size 35mm HC-51MJ. Include the quantity and the required elastomer option with the enquiry.