Metal bellow balanced pump mechanical seals WMF95N

Features

For unstepped shafts
Rotating bellows
Single Seal
Balanced
Independent of direction of rotation
Roller bellows

Advantages

For extreme temperature ranges
No dynamically loaded O-Ring
Very good self cleaning effect
Suitable for low-end sterile applications

Recommended applications

Process industry
Oil and gas industry
Refining technology
Chemical industry
Pharmaceutical industry
Pulp and paper industry
Food and beverage industry
Hot media
Cold media
Highly viscous media
Pumps
Special rotating equipment

Operating range

Shaft diameter:
d1 = 14 … 100 mm (0.55“ … 3.94“)
Temperature:
t = -40 °C …+220 °C (-40 °F … +428 °F)
Pressure: p = 16 bar (232 PSI)
Sliding velocity: vg = 20 m/s (66 ft/s)
Axial movement: ± 0.5 mm

Combination material

Seal face: Silicon carbide (Q12), Carbon graphite resin impregnated (B), Carbon graphite antimony impregnated (A)
Seat: Silicon carbide (Q1)
Bellows: Hastelloy® C-276 (M5)
Metal parts: CrNiMo steel (G1)

wmf95n

WMF95N Data Sheet of Dimension (mm)

WMF95N data sheet of dimension

Description

Metal bellow balanced pump mechanical seals WMF95N is a replacement seal supplied for general pump duty. Typical duty is pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

Internally the seal uses a welded metal bellows that takes the elastomer out of the load path. The face pair is carbon graphite running on silicon carbide; secondary seals are NBR. The unit is unbalanced, which suits the lower pressure range it is designed for.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.

Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.

EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the mechanical seal line. Two close alternatives are welded type metal bellow mechanical seal John crane W680 for pump and WMFWT80 Metal Bellow mechanical seals replace Burgmann MFLWT80. Include the quantity and the required elastomer option with the enquiry.

The reference carried by this unit is WMF95N. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.