
mechanical seal for Inoxpa SLR, Jabsco & Prolac Pumps replace Vulcan 50
Product parameter
| Temperature | -30℃ to 200℃, dependent on the elastomer |
| Pressure | Up to 10 bar |
| Speed | Up to 15 m/s |
| End play/axial float allowance | ±0.1mm |
| Size | 15.8mm 25.4mm 38.1mm |
| Face | Carbon, SIC, TC |
| Seat | SUS304, SUS316, SIC, TC |
| Elastomer | NBR, EPDM, VITON etc. |
| Spring | SS304, SS316 |
| Metal parts | SS304, SS316 |
Description
mechanical seal for Inoxpa SLR, Jabsco & Prolac Pumps replace Vulcan 50 is a like-for-like replacement unit for standard pump seal chambers. Most units go into cooling water and service water circuits. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Faces are silicon carbide against carbon graphite, with FKM secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the OEM mechanical seals line. Related units in the same family include APV-1 OEM Mechanical seals for pumps, replace Vulcan type 16. PLUS and Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC. Include the quantity and the required elastomer option with the enquiry.