


LWR-4 Mechanical seals 22mm/ 26mm for Lowara pump SV and e-SV series
Mechanical seals compatible with different models of Lowara® pumps. Different types in various diameters and combinations of materials: graphite-aluminium oxide, silicon carbide-silicon carbide, combined with different types of elastomers: NBR, FKM and EPDM.
Size: 22, 26mm
Temperature: -30℃ to 200℃, dependent on the elastomer
Pressure:Up to 8 bar
Speed: up to 10m/s
End Play /axial float Allowance: ±1.0mm
Material:
Face: SIC/TC
Seat: SIC/TC
Elastomer: NBR EPDM FEP FFM
Metal parts: S304 SS316
Description
When the original Lowara seal is discontinued or on long lead, LWR-4 Mechanical seals 22mm/ 26mm for Lowara pump SV and e-SV series is the replacement that keeps the pump running. Typical duty is building services and HVAC plant. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Standard build pairs silicon carbide with carbon graphite faces and FKM O-rings.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Keep the faces clean during fitting; a single grit particle will open a leak path.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the OEM mechanical seals line. Two close alternatives are LWR-2 16mm pump mechanical seals for Lowara pump replace Roten 5-16mm and LWR-1 12mm pump mechanical seals for Lowara pump replace Roten 5-12mm. Include the quantity and the required elastomer option with the enquiry. Compatibility is confirmed from the pump nameplate and the original part number, not from the seal size alone.