LWR-2 16mm pump mechanical seals for Lowara pump replace Roten 5-16mm

Operation Conditions

Temperature: -20℃ to 200℃ dependent on the elastomer
Pressure: Up to 8 bar
Speed: Up to 10m/s
End Play /axial float Allowance:±1.0mm
Size: 16mm

Material

Face: Carbon, SiC, TC
Seat: Ceramic, SiC, TC
Elastomer: NBR, EPDM, VIT, Aflas, FEP
Other Metal Parts : SS304, SS316

Description

LWR-2 16mm pump mechanical seals for Lowara pump replace Roten 5-16mm covers Lowara pump duty as a direct replacement for the original part. It is normally specified for pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. The face pair is silicon carbide running on carbon graphite; secondary seals are EPDM.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.

Clean the chamber and the shaft before fitting; grit left in the bore will tilt the gland. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Orders are matched on pump model, shaft size and medium. The unit belongs to the Victor’s OEM seal replacement line. Related units in the same family include LWR-3 mechanical seals 16mm for LOWARA pump replace Roten UNE5-16MM and LWR-1 12mm pump mechanical seals for Lowara pump replace Roten 5-12mm. Include the quantity and the required elastomer option with the enquiry. Cross-reference is by pump model and part number, with the shaft and casing dimensions confirmed before the order is released.