High-quality replacement of Grundfos-2 mechanical seals

Operating range

this is single-spring, O-ring mounted. semi-cartridge seals with threaded Hex-head. Suit for GRUNDFOS CR, CRN and Cri-series pumps

Shaft Size: 12MM,16MM,22MM

Pressure: ≤1MPa

Speed: ≤10m/s

Temperature: -30°C~ 180°C

Combination materials

Rotary Face
Silicon carbide (RBSIC)
Tungsten carbide
Stationary Seat  
Silicon carbide (RBSIC)
Carbon graphite resin impregnated
Tungsten carbide

Auxiliary Seal
Ethylene-Propylene-Diene (EPDM) 

Fluorocarbon-Rubber (Viton)
Spring
Stainless Steel (SUS304) 
Stainless Steel (SUS316)   
Metal Parts
Stainless Steel (SUS304) 
Stainless Steel (SUS316)

Shaft Size

12mm, 16mm,22mm

FAQ

Q: Do you provide free samples?

A: Yes, we can arrange the free samples with freight collect.

Q: What do you usually shipped through?

A: we can ship the goods by express, by air, by sea according to customer requirement.

Q: What’s your payment terms?

A: We accept T/T in advance before the goods are ready for ship.


Q: I cannot find our products in your catalogue, can you make customized products for us?

A: Yes, customized products is available. OEM is welcomed.
Q: I don’t have drawing or picture available for custom products, could you design it?


A: Yes, we can make the best suitable design in accordance with your application.

Description

High-quality replacement of Grundfos-2 mechanical seals is a replacement mechanical seal for Grundfos pumps, built to the original mounting envelope. Most units go into light-duty chemical transfer. Bore and shaft tolerances follow the original part, so no adaptor is needed.

Internally the seal uses a cartridge build that is set on the bench and fitted as one unit. Standard build pairs tungsten carbide with silicon carbide faces and FKM O-rings. It is a balanced design, so face loading stays controlled as pressure rises.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.

Check the shaft for wear at the secondary seal track and the chamber for scoring before the new unit goes on. A seal that has run dry shows heat colouring on the faces before it shows a leak.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the OEM mechanical seals line. Related units in the same family include Grundfos-10 Replacement mechanical seals 22mm for Grundfos pump and Grundfos-3 Single spring mechanical seals to suit Grundfos pump. Include the quantity and the required elastomer option with the enquiry.