


Grundfos pump mechanical seals shaft size 32mm
32mm shaft size for Grundfos pump water pump
Description
Grundfos pump mechanical seals shaft size 32mm is used to replace the original seal on Grundfos pumps in service, on the same shaft and chamber dimensions. Typical duty is food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. The face pair is carbon graphite running on silicon carbide; secondary seals are NBR.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Before fitting, record shaft diameter, seal chamber bore and depth; the axial working height is set from those three measurements, not from the old seal alone. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM mechanical seals selection line. For a different shaft size, see Grundfos-3 Single spring mechanical seals to suit Grundfos pump or OEM Grundfos-1 Type H pump mechanical seals. Include the quantity and the required elastomer option with the enquiry. The part number and the pump model are the two things to match; the set is then checked against the original drawing before it ships.