Grundfos-7 Southern CNP Calpeda pump seal TD5 48mm 55mm multistage

Operational Conditions

Temperature:-20 to +100℃
Pressure:≤2.5Mpa
Speed:≤10m/s

Combination materials

CAR/SIC/EPDM

Shaft size

40mm 43mm 48mm 55mm 60mm

Grundfos 7 Shaft size

Description

Grundfos-7 Southern CNP Calpeda pump seal TD5 48mm 55mm multistage is supplied as a like-for-like replacement for Grundfos pump applications. It is normally specified for food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Standard build pairs silicon carbide with carbon graphite faces and EPDM O-rings.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.

Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. A seal that has run dry shows heat colouring on the faces before it shows a leak.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM mechanical seals line. Two close alternatives are Grundfos-5 mechanical seal for CNP-CDL series Grundfos pump and GLF-14 Grundfos pump mechanical seal 22mm. Include the quantity and the required elastomer option with the enquiry. The part number and the pump model are the two things to match; the set is then checked against the original drawing before it ships. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.