
Grundfos-6 Lower mechanical seal replace AES M010SA
Operating ranges
Temperature:-30℃ to +200℃
Pressure:≤2.5Mpa
Speed:≤15m/s
Combination Materials
Rotary Face
Silicon carbide (RBSIC)
Tungsten carbide
Stationary Seat
Silicon carbide (RBSIC)
Carbon graphite resin impregnated
Tungsten carbide
Auxiliary Seal
Ethylene-Propylene-Diene (EPDM)
Fluorocarbon-Rubber (Viton)
Spring
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Metal Parts
Stainless Steel (SUS304)
Stainless Steel (SUS316)
Shaft size
25mm, 32mm, 38mm, 50mm, 65mm
Description
Grundfos-6 Lower mechanical seal replace AES M010SA is a drop-in replacement unit for Grundfos pumps, matched on shaft size and working height. Typical duty is cooling water and service water circuits. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Standard build pairs tungsten carbide with silicon carbide faces and FKM O-rings. The unit is unbalanced, which suits the lower pressure range it is designed for.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.
Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the Victor’s OEM pump seals line. Related units in the same family include GLF-14 Grundfos pump mechanical seal 22mm and Grundfos-5 mechanical seal for CNP-CDL series Grundfos pump. Include the quantity and the required elastomer option with the enquiry.