Grundfos-13 long type mechanical seals for Grundfos SA pump

Operational Conditions:

Temperature: -20ºC to +180ºC

Pressure: ≤2.5MPa

Speed: ≤15m/s

Materials:

Stationary Ring: Ceramic, Silicon Carbide, TC

Rotary Ring: Carbon, Silicon Carbide

Secondary Seal: NBR, EPDM, Viton, PTFE

Spring and Metal Parts: Steel

3. Shaft size: 50mm:

4. Applications: Clean water, sewage water, oil and other moderately corrosive fluids

Description

Grundfos-13 long type mechanical seals for Grundfos SA pump is a drop-in replacement unit for Grundfos pumps, matched on shaft size and working height. Typical duty is process water in general industry. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Standard build pairs silicon carbide with carbon graphite faces and FKM O-rings. It is a balanced design, so face loading stays controlled as pressure rises.

Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.

Check the shaft for wear at the secondary seal track and the chamber for scoring before the new unit goes on. A seal that has run dry shows heat colouring on the faces before it shows a leak.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM mechanical seals line. For a different shaft size, see Grundfos-12 60mm long type mechanical seals for Grundfos SA pump or Grundfos-4 pump mechanical seals suitable for Grundfos Type B. Include the quantity and the required elastomer option with the enquiry. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start.