Fristam-3 pump seal replacement of Vulcan W3001-1, W3501-1

Replacement

Vulcan W3001-1, W3501-1

Design

Center Seat with lapped faces

Material

SUS304, VITON

Shaft Size

30mm, 35MM

Description

Fristam-3 pump seal replacement of Vulcan W3001-1, W3501-1 is the replacement option for Fristam pumps where the factory part is no longer stocked. It is normally specified for pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. The face pair is carbon graphite running on silicon carbide; secondary seals are FKM.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.

Clean the chamber and the shaft before fitting; grit left in the bore will tilt the gland. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. Keeping one unit on the shelf cuts the downtime that follows a leak, since the pump does not have to wait for a part to arrive.

Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM mechanical seals factory line. Two close alternatives are Fristam-1 pump mechanical seals replace Vulcan W-2201/1 and Fristam-2 Single spring mechanical seals for Fristam FP/FL/FT Pump. Include the quantity and the required elastomer option with the enquiry.

The reference carried by this unit is W3001. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.