
Fristam-1 pump mechanical seals replace Vulcan W-2201/1
Material
SUS304/Viton
Shaft Size
30mm
Used in the following pumps
Fristam pumps FP, FPX Size 633: 1802600004, 1802600002, 1802600000, 1802600003, 1802600295,
Fristam pumps Split-2 piece Mating ring: 1802600005, 1802600135, 1802600006, 1802600140
Fristam pumps FP, FPX size 735: 1802600296, 1802600127, 1802600128, 1802600288, 1802600312
Fristam pumps tapered mating ring ID: 1802600310
Fristam pumps FP, FPX size 735 split 2 piece mating ring:1802600129, 1802600143, 1802600130, 1802600142;
Fristam pumps FP, FPX size 736: 1802600337, 1802600009, 1802600131, 1802600301, 1802600328
Fristam pumps Split-2 piece Mating ring: 1802600132, 1802600141, 1802600139, 1802600393.
Fristam pumps FPR: 1802600639, 1802600651, 1802600678, 1802600845, 1802600775.
Fristam pumps FT: 1802600027, 1802600340, 1802600306.
Fristam pumps FZX 2000 Mixer Pump: 1802600014, 1802600012, 1802600010, 1802600016.
Description
When the original Fristam seal is discontinued or on long lead, Fristam-1 pump mechanical seals replace Vulcan W-2201/1 is the replacement that keeps the pump running. It is normally specified for marine and offshore auxiliary pumps. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Faces are carbon graphite against silicon carbide, with FKM secondary sealing as standard.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. A short dry run is enough to score the faces, so prime the chamber before start-up.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. A seal that has run dry shows heat colouring on the faces before it shows a leak.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Orders are matched on pump model, shaft size and medium. The unit belongs to the OEM seal replacement line. Two close alternatives are Fristam-2 Single spring mechanical seals for Fristam FP/FL/FT Pump and Alfa laval-1 pump mechanical seals replace Vulcan type 92B. Include the quantity and the required elastomer option with the enquiry. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.