

Flygt 8 mechanical shaft seal replacing Flygt Griploc
PRODUCT FEATURES
Resistant to heat, clogging and wear
Outstanding leakage prevention
Easy to mount
Product Descrption
Shaft size: 20mm
For pump model 2075,3057,3067,3068,3085
Material: Tungsten carbide/Tungsten carbide/ Viton
Kit inludes: Upper seal, lower seal, and O ring
Description
Flygt 8 mechanical shaft seal replacing Flygt Griploc is used to replace the original seal on Flygt pumps in service, on the same shaft and chamber dimensions. It is normally specified for process water in general industry. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Internally the seal uses O-ring mounting that keeps the spring out of the pumped medium. Standard build pairs tungsten carbide with silicon carbide faces and FKM O-rings. It is a balanced design, so face loading stays controlled as pressure rises.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.
Before fitting, record shaft diameter, seal chamber bore and depth; the axial working height is set from those three measurements, not from the old seal alone. The first signs of wear are a slow leak at the secondary seal and a light polish on the faces.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the Victor’s OEM pump seals line. For a different shaft size, see Flygt 10 replacing mechanical seal for 3102 Flygt Pumps Grindex FJL-25 or Flygt 9 replacement Griploc mechanical seal for Flygt pump and mixer. Include the quantity and the required elastomer option with the enquiry.