
Flygt 10 replacing mechanical seal for 3102 Flygt Pumps Grindex FJL-25
Features
Shaft size: 25mm
Face: TC/TC/VIT for Upper;
TC/TC/VIT for Lower
Elastomer: VIT
Metal Parts: Stainless Steel 304
Description
Flygt 10 replacing mechanical seal for 3102 Flygt Pumps Grindex FJL-25 is the replacement option for Flygt pumps where the factory part is no longer stocked. Most units go into pulp and paper process water. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Standard build pairs tungsten carbide with silicon carbide faces and NBR O-rings.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. A seal that has run dry shows heat colouring on the faces before it shows a leak.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the OEM mechanical seals line. Two close alternatives are Flygt 7 25mm mechanical seal for Flygt 3102 submersible sewage pump and Flygt 8 mechanical shaft seal replacing Flygt Griploc. Include the quantity and the required elastomer option with the enquiry. The part number and the pump model are the two things to match; the set is then checked against the original drawing before it ships.