
EMU Mechanical Seal 35/50/75mm for Wilo EMU Pump
Operational Conditions:
Working Temperature:-30℃ — 200℃
Working pressure: ≤ 2.5MPA
Linear Speed: ≤ 15m/s
Combination materials
Stationary Ring (Carbon/SIC/TC)
Rotary Ring (SIC/TC/Carbon)
Secondary Seal (NBR/EPDM/VITON)
Spring & Other Parts (SUS304/SUS316)
EMU data sheet of dimension(mm)
Description
EMU Mechanical Seal 35/50/75mm for Wilo EMU Pump is a replacement mechanical seal for EMU pumps, built to the original mounting envelope. Most units go into clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. The face pair is tungsten carbide running on silicon carbide; secondary seals are FKM. The unit is unbalanced, which suits the lower pressure range it is designed for.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Send the nameplate data with the model and shaft size, and the unit is checked against the original drawing. The unit belongs to the Victor’s OEM pump seals line. Related units in the same family include Metal Bellow Cartridge Mechanical Seal for Naniwa Pump BBH-50DNC and OEM cartridge mechanical seal for taiko kikai marine pump shaft size 35mm HC-51MJ. Include the quantity and the required elastomer option with the enquiry.