Elastomer rubber mechanical seals Vulcan Type 19B for water pump

Description

Elastomer rubber mechanical seals Vulcan Type 19B for water pump is a like-for-like replacement unit for standard pump seal chambers. Typical duty is marine and offshore auxiliary pumps. Bore and shaft tolerances follow the original part, so no adaptor is needed.

The working element is a spring-loaded pusher assembly. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard. The unit is unbalanced, which suits the lower pressure range it is designed for.

Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. A short dry run is enough to score the faces, so prime the chamber before start-up.

Set the working height from the measured chamber depth rather than from the worn seal, then check face squareness before the pump goes back together. A seal that has run dry shows heat colouring on the faces before it shows a leak.

As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.

Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the Victor’s mechanical seals line. For a different shaft size, see WEMG1 rubber bellow mechanical shaft seal for water pump or Conical ‘O’-Ring Mounted Mechanical Seals Vulcan Type 8 DIN. Include the quantity and the required elastomer option with the enquiry. Compatibility is confirmed from the pump nameplate and the original part number, not from the seal size alone.