


Eagle burgmann multi spring H75F mechanical seals for water pump
| Detail Information | |||
| Material: | SIC SIC FKM | Function: | For Oil Pump, Water Pump |
| Transport Package: | Box | HS Code: | 848420090 |
| Specification: | Burgmann Pump Mechanical Seal H7N | Certificate: | ISO9001 |
| Type: | For Mechanical Shaft Seal H7N | Standard: | Standard |
| Style: | Burgmann Type H75 O -ring Mechanical Seal | Product Name: | H75 Burgmann Mechanical Seals |
Operational Conditions
Wave Spring Mechanical Seal
Self cleaning effect
Short Installation length possible (G16)
Temperature: -20 – 180℃
Speed: ≤20m/s
Pressure: ≤2.5 Mpa
Wave Spring Seal Burgmann-H7N Can be widely used in Clean water, sewage water, Oil and other moderately corrosive fluids
Combination material
Rotary face: Stainless steel/Carbon/Sic/TC
Stat Ring: Carbon/Sic/TC
Seat Type: Standard SRS-S09, Alternative SRS-S04/S06/S92/S13
SRS-RH7N have pump ring design which called H7F
Performance Capabilities
| Temperature | -30℃ to 200℃, dependent on the elastomer |
| Pressure | Up to 16 bar |
| Speed | Up to 20 m/s |
| End play/axial float allowance | ±0.1mm |
| Size | 14mm to 100mm |
| Brand | JR |
| Face | Carbon, SiC, TC |
| Seat | Carbon, SiC, TC |
| Elastomer | NBR, EPDM, etc. |
| Spring | SS304, SS316 |
| Metal parts | SS304, SS316 |
| Idividual Packing | Using foam and plastic paper wrapped, then put one piece of seal in one box,finally put in standard export carton. |
Description
Eagle burgmann multi spring H75F mechanical seals for water pump is a replacement seal supplied for general pump duty. Most units go into food and beverage process lines. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Sealing geometry follows the original, built around a multi-spring carrier that spreads the spring load evenly over the sealing face. The face pair is silicon carbide running on carbon graphite; secondary seals are FKM.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Keep the faces clean during fitting; a single grit particle will open a leak path.
Clean the chamber and the shaft before fitting; grit left in the bore will tilt the gland. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Quote the pump model, shaft diameter and medium when enquiring, and the seal is matched to the original part number. The unit belongs to the mechanical seal line. For a different shaft size, see O ring carbon mechanical seals 166 for water pump or WHJ92N Wave Spring Mechanical Seals Replacement For Burgmann HJ92N. Include the quantity and the required elastomer option with the enquiry.
The reference carried by this unit is H75F. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.