
APV-2 pump seals replace Vulcan type 26 series and AES P06 series
Operation Parameters
Temperature: -20ºC to +180ºC
Pressure: ≤2.5MPa
Speed: ≤15m/s
Combination Materials
Stationary Ring: Ceramic, Silicon Carbide, TC
Rotary Ring: Carbon, Silicon Carbide
Secondary Seal: NBR, EPDM, Viton, PTFE
Spring and Metal Parts: Steel
Applications
Clean water
sewage water
oil and other moderately corrosive fluids
APV-2 data sheet of dimension
Description
APV-2 pump seals replace Vulcan type 26 series and AES P06 series is supplied as a like-for-like replacement for APV pump applications. Most units go into light-duty chemical transfer. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a spring-loaded pusher assembly. Standard build pairs silicon carbide with carbon graphite faces and FKM O-rings.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Running the pump dry, even briefly, will damage the faces.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. A seal that has run dry shows heat colouring on the faces before it shows a leak.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Replacing the complete unit rather than single components avoids re-setting the working height, which is where most repeat failures start. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Pricing and availability follow the pump model and shaft size given on the enquiry. The unit belongs to the OEM mechanical seals line. Two close alternatives are APV-1 OEM Mechanical seals for pumps, replace Vulcan type 16. PLUS and APV World Series APV-3 double mechanical seal replaces Vulcan type 16. Include the quantity and the required elastomer option with the enquiry.
The reference carried by this unit is P06. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.