

ABS-1 Upper wave spring mechanical seals for ABS pump
Description
ABS-1 Upper wave spring mechanical seals for ABS pump replaces the original seal on ABS pumps without changing the housing or the shaft. It is normally specified for clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.
The working element is a wave spring that keeps the axial stack short while holding uniform face pressure. Faces are carbon graphite against silicon carbide, with NBR secondary sealing as standard.
Temperature, pressure and speed limits depend on the face and elastomer combination, so the duty point should be checked against the datasheet before the order is released. Keep the faces clean during fitting; a single grit particle will open a leak path.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. A seal that has run dry shows heat colouring on the faces before it shows a leak.
As a rule, EPDM suits water-based duty, FKM suits oils and fuels, and FFKM is used where solvents would swell the other two. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Replacement orders are confirmed against the original part number and the shaft size. The unit belongs to the OEM mechanical seals line. For a different shaft size, see WALP OEM pump mechanical seals for KRAL pump, ALP series or Flygt-6 High Quality Upper and Lower Mechanical Seals for Flygt 3085 pump. Include the quantity and the required elastomer option with the enquiry.