
190497 22MM IMO marine pump mechanical seal
Product Parameters
22MM Imo Pump Seal 190497, Marine Pump Mechanical Seal | ||
Operational Conditions | Size | Material |
| Temperature: -40℃ to 220℃ depend on the elastomer | 22MM | Face: SS304, SS316 |
| Pressure: Up to Up to 25 bar | Seat: Carbon | |
| Speed: Up to 25 m/s | O-rings: NBR, EPDM, VIT | |
| End Play /axial float Allow: ±1.0mm | Metal parts: SS304, SS316 | |
We can provide follow IMO ACE 3 generation pump spare parts.
Code: 190497,190495,194030,190487,190484,190483,189783.
IMO ACE 3 pump spare parts secondary seal 190468,190469.
pump mechanical seal parts-22mm
triple rotors screw pump
fuel oil supply system for ship in marine
ACE ACG series
high temp. mechanical seals.
Imo pump mechanical seal parts-22mm
1. IMO ACE025L3 pump to suit mechanical shaft seal 195C-22mm, Imo 190495 (wave spring)
2. IMO-190497 ACE pump mechanical seal for marine industry, Imo 190497 (coil spring)
3. IMO ACE 3 pump spare parts shaft seal 194030, Imo 194030 (coil spring)
Description
190497 22MM IMO marine pump mechanical seal is used to replace the original seal on IMO pumps in service, on the same shaft and chamber dimensions. It is normally specified for clean water and light chemical service. Bore and shaft tolerances follow the original part, so no adaptor is needed.
Sealing geometry follows the original, built around O-ring mounting that keeps the spring out of the pumped medium. Standard build pairs carbon graphite with silicon carbide faces and EPDM O-rings. The unit is unbalanced, which suits the lower pressure range it is designed for.
Exact limits follow the face material and elastomer choice; confirm the duty point against the datasheet for the specific build. Running the pump dry, even briefly, will damage the faces.
Fitting follows the standard procedure: measure shaft diameter, chamber depth and working height, then set the seal to the recorded dimension before the pump is reassembled. Wear normally appears first at the faces, then at the secondary seals; a leaking unit usually shows both by the time it is pulled.
EPDM covers water and dilute chemical service but not mineral oils; FKM handles oils, fuels and many solvents; FFKM is reserved for aggressive media where the softer elastomers swell. Fitting a complete replacement keeps the face load and working height as they left the factory, rather than rebuilding the stack on site. A spare on site is worth holding for critical pumps, where a leaking seal takes the whole line out of service.
Orders are matched on pump model, shaft size and medium. The unit belongs to the Victor’s OEM seal replacement line. Two close alternatives are Marine pump mechanical seals for IMO 190340 and IMO low pressure pump ACD series shaft mechanical seal XTXX 190810. Include the quantity and the required elastomer option with the enquiry.
The reference carried by this unit is 190497. Confirm that reference against the pump nameplate and the shaft size before the order is placed, since later versions of the same pump can use a different seal arrangement.